VRRP interface binding in a single node active cluster

Last published : Sep 22, 2026
When you migrate a high availability (HA) setup to a cluster setup, all configurations must be compatible and must be supportable in the cluster. To achieve this, you can now configure virtual router IDs (VRIDs and VRID6s) on a node interface.
Important
Currently, only a single-node active cluster system supports VRIDs and VRID6s.
For instructions for configuring VRIDs and VRID6s, see Configuring Virtual MAC Addresses.
To configure a virtual router ID on a single-node active cluster, add the VRID or VRID6 and bind it to the cluster-node interface.
To add a VRID by using the NetScaler CLI
At the command prompt, type:
add vrID <ID>
To bind a VRID to the cluster-node interface by using the NetScaler CLI
At the command prompt, type:
Bind vrid &lt;ID> -ifnum &lt;interface_name> | -trackifNum <interface_name

Add vrID 100
Bind vrid 100 –ifnum 1/1  1/2
done
To add a VRID6 by using the NetScaler CLI
At the command prompt, type:
add vrID6 &lt;ID>
To bind a VRID6 to a cluster node interface by using the CLI
At the command prompt, type:
bind vrid6 &lt;ID> -ifnum &lt;interface_name> | -trackifNum &lt;interface_name>

Add vrID6 100
Bind vrid6 100 –ifnum 1/1  1/2
Done
Related information