Enable NetScaler Web App Firewall
Before you can create a security configuration, you must enable the NetScaler Web App Firewall feature on the appliance.
Related information
Points to remember
-
If you are configuring a dedicated NetScaler Web App Firewall appliance or upgrading an existing appliance, the feature is already enabled. You do not have to perform either of the procedures described here.
-
If you have a new NetScaler or VPX, you must enable the NetScaler Web App Firewall feature before you configure it.
-
If you are upgrading a NetScaler or VPX from a previous version, you must first enable the NetScaler Web App Firewall feature before you configure it.
Note:
If you are upgrading a NetScaler or VPX from a previous version, you might need to update the licenses on your appliance before you enable NetScaler Web App Firewall. Check with your NetScaler representative or reseller to obtain the correct license.
Enable NetScaler Web App Firewall by using the command interface
At the command prompt, type the following command:
enable ns feature AppFW
Enable the Web App Firewall by using the GUI
-
Navigate to System > Settings.
-
In the details pane, click Configure Advanced Features.
-
In the Configure Advanced Features page, select NetScaler Web App Firewall.
-
Click OK.